Introduction

Your BAS light, or Brake Assist System light, is an important indicator of the health of your car’s braking system. It is designed to alert you when there is a problem with the brakes and should be taken seriously. If it comes on, it means that something needs to be fixed before you can safely drive your vehicle again. Fortunately, resetting the BAS light isn’t difficult and can usually be done in just a few minutes. In this article we will discuss what causes the BAS light to come on and how to reset it once it has been triggered. 

What Does ESP On A Car Mean?

If you want to know that what is esp on a car means then ESP stands for Electronic Stability Program (or Control). This system helps keep your car stable by automatically adjusting its brakes when needed in order to maintain control during sharp turns or sudden stops. The ESP works together with other safety systems such as ABS (anti-lock braking system) and traction control in order to ensure that your car remains stable at all times while driving. 

Why Is My BAS Light On?

The most common reason for a BAS light coming on is due to low brake fluid levels or a faulty brake pad sensor. Other possible causes include worn out brake pads, damaged rotors or calipers, air bubbles in the brake lines, loose wheel bearings or even electrical issues within the vehicle itself. Whatever the cause may be, if your BAS light comes on then you need to have it checked out immediately by a qualified mechanic so they can diagnose and repair any underlying problems before continuing use of your vehicle.  

 How To Reset Your Bas Light?

Once you have identified and repaired any underlying issues causing your BAS light to come on then you are ready for resetting procedure:  

 Step 1: Start up Your Vehicle – Make sure that all doors are closed and turn ignition key from off position until dashboard lights illuminate but do not start engine yet; leave key in this position for about 10 seconds before turning back off again completely; wait another 10 seconds before repeating process two more times (total 3 cycles).   

 Step 2: Check Dashboard Lights – After completing step one check dashboard lights again; if “BAS” warning lamp still illuminated then proceed directly onto next step otherwise skip ahead as no further action required at this point!  

 Step 3: Press Brake Pedal – With engine still turned off press down firmly but slowly onto brake pedal several times over course of 5-10 seconds until “BAS” warning lamp extinguishes; once extinguished release pressure from pedal completely before starting engine normally as normal operation resumed!    

 Conclusion

Resetting your bas light isn't difficult but requires some patience since multiple steps must be followed correctly in order for procedure work properly without issue afterwards - failure follow these instructions could result permanent damage being caused which would require costly repairs fix later down line! Always remember take extra care whenever dealing with vehicles make sure everything done according manufacturer's specifications avoid unnecessary complications future reference too!