grinding dust collector supplier's operating temperature is an important basis for design, and the operating temperature error sometimes leads to serious consequences. If a grinding dust collector supplier wants to maintain the grinding Dust Collector for a long time, it needs to maintain and overhaul each part of the device regularly. Maintenance methods and procedures are usually performed by technicians. If the pulse valve fails, it should be removed in time. If there are impurities and moisture inside, it should be cleaned up. If the diaphragm is damaged, it should be replaced in time. When shutting down, after the process system stops, keep the grinding dust collector supplier and exhaust fan working for a period of time to dust the moisture and dust in the equipment. It should be noted that when the dust collector stops working, the dust collector needs to be cleaned repeatedly (manual cleaning is available). Remove the dust on the dust filter bag to prevent moisture from burning the bag. The timing cleaning controller should be used to determine whether the cleaning period is accurate on a regular basis, otherwise it should be adjusted. When using fixed-resistance pulse controller, the working condition of the pressure switch should be checked regularly, and whether the pressure port is blocked and cleaned.

Next, talk about the practical use points of grinding dust collector supplier:

1. Choose the filtering speed correctly to determine the cleaning rate of the dust collector -- the filtering speed of the dust collector supplier is directly related to the dust collector resistance and the dust concentration at the inlet of the treatment flue gas. For the grinding dust collector supplier produced in China, the resistance of the dust collector is limited to 120 mm water column.

2. grinding dust collector supplier adopts upper cover to improve maintenance conditions -- this is similar to single bag dust collector supplier, grinding dust collector supplier is external filter type continuous dust cleaning. The filter bag room is located on the side of the dust bearing air flow. When the side door is used, the dust collector cannot enter the filter bag room during operation, and the working conditions of the maintenance personnel are also bad when the machine is shut down for maintenance.

A grinding dust collector supplier should be familiar with the daily working conditions of control valves, pulse valves and timers during the use of Grinding Dust Collector. grinding dust collector supplier common faults include the failure of pulse valve rubber diaphragm, which directly affects the cleaning effect. grinding dust collector supplier is a supplier of external filter type, which installs the frame inside the bag. The staff should check all parts fixing the filter bag to see if the screws and nuts are relaxed, whether the tension of the filter bag is correct, etc., so as to ensure normal operation.

The use of compressed air cleaning, so it requires the removal of oil mist and water droplets, and the oil and water separator to do a good job of cleaning, in order to prevent the failure of the motion mechanism and the blockage of the filter bag. It is also necessary to deal with whether the air volume of the dust collector and the pressure and temperature of each test point are corresponding in the design, and it is necessary to check the installation of the filter bag, and check whether the bag is dropped, loosened and worn after use, which can be judged by the discharge of the chimney after being put into operation. It is very important to prevent condensation. In the use of equipment, it is necessary to prevent the gas from cooling below the dew point in the bag room, and pay attention to the grinding dust collector supplier when using the grinding dust collector under negative pressure. Because the shell may often have air leakage, resulting in the bag room gas temperature below the dew point, the filter bag will be damp, can not work, so this point also needs to be paid attention to. At the same time, before the single grinding dust collector supplier stops working, for example, it needs to clean and unload ash, and then it can discharge water regularly according to the water in the water separator in the compressed air system.

grinding dust collector supplier https://www.kaisenfilter.com/Grinding-Dust-Collector